-
Specifications
-
Standard/Optional Equipment
Maximum Power
121hp
Maximum Torque
369lb-ft @ 1500 rpm
Rated Speed
2200-2400 rpm
Minimum Power
74hp
Emissions
UN ECE R96 Stage IIIA, Brazil MAR-1
Engine Configuration
Inline 4, 4-Stroke-Cycle Diesel
Bore
3.9in
Stroke
4.7in
Displacement
220in³
Compression Ratio
17.0:1
Aspiration
Turbocharged Aftercooled (TA)
Combustion System
Direct Injection
Rotation from Flywheel End
Counterclockwise
Aftertreatment
-
Length
26.3in
Width
22.2in
Height
31in
Weight - Net Dry - Basic Operating Engine Without Optional Attachments
840lb
Control System
Starter motor (12V or 24V)
Alternator (12V or 24V)
Electronic Control Unit (chassis mounted)
Engine control sensors and robust wiring harness
Data interface via CANbus J1939
Flywheels and Flywheel Housing
Flywheel housings - SAE 3 or SAE 4
Choice of flywheel to match industry common hydraulic pumps and transmissions
Side PTO with SAE A or SAE B interface
Fuel System
Fuel filter - preconnected but chassis mounted
With water sensor
Lube System
Lubricating oil filters
High incline oil pan - 35 degrees continuous in all directions
General
Cold start capability to -20° C (-4° F)
Paint: Caterpillar yellow, with optional colors available at request
ALL
Control System
Starter motor (12V or 24V)
Alternator (12V or 24V)
Electronic Control Unit (chassis mounted)
Engine control sensors and robust wiring harness
Data interface via CANbus J1939
Flywheels and Flywheel Housing
Flywheel housings - SAE 3 or SAE 4
Choice of flywheel to match industry common hydraulic pumps and transmissions
Side PTO with SAE A or SAE B interface
Fuel System
Fuel filter - preconnected but chassis mounted
With water sensor
Lube System
Lubricating oil filters
High incline oil pan - 35 degrees continuous in all directions
General
Cold start capability to -20° C (-4° F)
Paint: Caterpillar yellow, with optional colors available at request