-
Specifications
-
Standard/Optional Equipment
Maximum Power
28.2hp
Maximum Torque
49.4lb-ft @ 2400 rpm
Rated Speed
2200-3400 rpm
Minimum Power
19.7hp
Emissions
U.S. EPA Tier 4 Interim Equivalent
Engine Configuration
Inline 3, 4-Stroke-Cycle Diesel
Bore
3in
Stroke
3.2in
Displacement
69in³
Compression Ratio
23.0:1
Aspiration
Naturally Aspirated (NA)
Combustion System
Indirect Injection
Rotation from Flywheel End
Counterclockwise
Aftertreatment
-
Length
19.3in
Width
15.7in
Height
22.7in
Weight - Net Dry - Basic Operating Engine Without Optional Attachments
191lb
Air Inlet System
Inlet manifold with choice of inlets.
Control System
Alternator 12 volt 40 amp
Starter motor 12 volt
Glow plug starting aid
Cooling System
Belt-driven coolant pump
Coolant temperature switch
Flywheel and Flywheel Housing
SAE No. 6 1/2 flywheel
Choice of SAE No. 5 or standard backplate flywheel housing
Fuel System
Fuel injection pump
Spin-on fuel filter
Electronic Shut-off Solenoid (ESOS)
Lube System
Low profile oil pan
Spin-on lube oil filter
Lube oil pressure switch
General
Cast iron, engine block
Cast iron exhaust manifold--side outlet
Paint: Caterpillar yellow, with optional colors available at request
ALL
Air Inlet System
Inlet manifold with choice of inlets.
Control System
Alternator 12 volt 40 amp
Starter motor 12 volt
Glow plug starting aid
Cooling System
Belt-driven coolant pump
Coolant temperature switch
Flywheel and Flywheel Housing
SAE No. 6 1/2 flywheel
Choice of SAE No. 5 or standard backplate flywheel housing
Fuel System
Fuel injection pump
Spin-on fuel filter
Electronic Shut-off Solenoid (ESOS)
Lube System
Low profile oil pan
Spin-on lube oil filter
Lube oil pressure switch
General
Cast iron, engine block
Cast iron exhaust manifold--side outlet
Paint: Caterpillar yellow, with optional colors available at request