-
Specifications
-
Standard/Optional Equipment
Maximum Power
35hp
Maximum Torque
78.1lb-ft @ 1800 rpm
Rated Speed
2400-2600 rpm
Minimum Power
31.6hp
Emissions
UN ECE R96 Stage IIIA
Engine Configuration
Inline 3, 4-Stroke-Cycle Diesel
Bore
3.3in
Stroke
3.9in
Displacement
101.4in³
Compression Ratio
23.0:1
Aspiration
Naturally Aspirated (NA)
Combustion System
Indirect Injection
Rotation from Flywheel End
Counterclockwise
Aftertreatment
-
Length
22.5in
Width
17.8in
Height
25.3in
Weight - Net Dry - Basic Operating Engine Without Optional Attachments
359lb
Air Inlet System
Inlet manifold with choice of inlets.
Control System
Alternator 12 volt 40 amp
Starter motor 12 volt
Glow plug starting aid
Cooling System
Belt-driven coolant pump
Coolant temperature switch
Choice of cooling fans
Flywheel & Flywheel Housing
SAE No. 6 1/2 flywheel
Choice of SAE No. 5 or standard backplate flywheel housing
Fuel System
Fuel injection pump
Spin-on fuel filter
Electronic Shut-off Solenoid (ESOS)
Lube System
Lube oil filter
Lube oil pressure switch
Lube oil sump
General
Cast iron, engine block
Cast iron exhaust manifold--side outlet
Cold start capability to -20° C (-4° F)
Gradeability 35° continuous
Paint: Caterpillar yellow, with optional colors available at request
ALL
Air Inlet System
Inlet manifold with choice of inlets.
Control System
Alternator 12 volt 40 amp
Starter motor 12 volt
Glow plug starting aid
Cooling System
Belt-driven coolant pump
Coolant temperature switch
Choice of cooling fans
Flywheel & Flywheel Housing
SAE No. 6 1/2 flywheel
Choice of SAE No. 5 or standard backplate flywheel housing
Fuel System
Fuel injection pump
Spin-on fuel filter
Electronic Shut-off Solenoid (ESOS)
Lube System
Lube oil filter
Lube oil pressure switch
Lube oil sump
General
Cast iron, engine block
Cast iron exhaust manifold--side outlet
Cold start capability to -20° C (-4° F)
Gradeability 35° continuous
Paint: Caterpillar yellow, with optional colors available at request