ALL
Air Inlet System
Dual turbochargers
Corrosion-resistant aftercooler core
Air cleaners — single or dual element
Exhaust System
Dry exhaust manifolds with thermo-laminated heat shields
Dual turbochargers with water-cooled bearings and thermo-laminated heat shields
Vertical exhaust outlet
Flange and exhaust expanders
Cooling System
Separate-circuit-aftercooler (SCAC) and jacket water (JW) circuit cooling system
Gear-driven centrifugal pumps, one for each circuit
SCAC electronic thermostat, outlet-controlled with aftercooler inlet temperature sensing
JW electronic thermostat, outlet-controlled with outlet temperature sensing
Engine oil cooler in JW circuit
Fuel System
Cat common rail high-pressure fuel system with electronically controlled unit injectors
Duplex primary fuel filter with water separator
Duplex secondary/tertiary fuel filters
Electric fuel priming pump
Gear-driven low pressure transfer pump
Gear-driven high pressure transfer pump
Double-walled high pressure fuel lines
Fuel pressure, temperature, and leak detection sensors
Lubrication System
Engine-driven, gear-type oil pump
Integral lube oil cooler
Front-mounted oil drain lines and valve
Oil sampling valve
Filler and dipstick
Four-canister simplex oil filter
Prelube pump — electric, air, or custom
Fumes disposal with crankcase breathers
Crankcase explosion relief valves
Engine Control and Protection
Dual ADEM A4 engine control unit (ECU) for redundancy
Software monitors engine parameters and performs alarm, derate, and shutdown functions
Rigid wiring harness
Marine Power Display 3.0 (MPD 3.0)
Mounting
Inner-outer base with vibration isolators
Generator
Kato brushless permanent magnet 6P6.6-3200 HR
2-bearing, close-coupled arrangement
60 Hz, 600V, 0.7 PF
UL/CSA listed, IP23
Flywheel and Coupling
Flywheel housing, SAE No. 00
Flywheel, SAE No. 00
ABS certified, non-certified, or custom-coupling and coupling mounting
Free-standing or close-coupled generator set arrangements
Starting System
Turbine air starter or
Dual electric starting motors or
Air and electric starting motors (redundant)
General
Power distribution box — 24V or custom
20A battery charger
Cat yellow paint
Offshore oil field sub-base
Integral spring isolators with limit stop
Lift provisions on base
Oil drain extension
Engine length drip pan with drain
Torsional dampened driveline couplings
Air Inlet System
Air cleaner service indicator
Cooling System
9 kW, 240V, 60 hz jacket water heater
Custom jacket water heater
Fuel System
Four canister duplex oil filter
Engine Control and Protection
Cat Alarm and Protection System
Communication module PL1000T/E
Direct-rack control
Thermocouples
Metal particle detector
SOLAS spray shielding
Mounting
Custom I-beam base with vibration isolators
Generator
Custom generator
General
TVA report
Special tests
Project-specific installation drawings
P&ID-electrical drawings
Spare parts kit
Barring group
Engine lifting group
Custom generators and radiators
