ALL

Air Inlet System

Single element canister type with service indicator

Air cleaner

Cooling

Package mounted radiator

Exhaust

Exhaust flange outlet

Fuel

Primary fuel filter with integral water separator

Fuel priming pump

Generator

IP23 Protection

Matched to the performance and output characteristics of Cat engines

Power Termination

Busbar

Starting/Charging

Heavy duty starting system

Charging alternator

Control Panel

Over/under voltage (27/59)

Emergency stop pushbutton

Speed adjust

Accessory module data link

Generator phase sequence

Panel lights

Alarm acknowledge

Generator mounted - rear facing

kW (per phase, average & percent)

Engine cool-down timer

Communications:

High coolant temperature

Warning/shutdown with common LED indication of shutdowns for:

Overcurrent (50/51)

Amps (per phase & average)

Oil pressure (psi, kPa or bar)

Serial annunciator module data link

24 Volt DC operation

Cat ECS controller includes:

DC volts

Reverse reactive power (kVAr) (32RV)

6 Programmable digital inputs

2 Programmable relay outputs (Form C)

Frequency (Hz)

Customer data link (Modbus RTU)

Power factor (per phase & average)

kW-hr (total)

Cat ECS 100

Lamp test

kVA (per phase, average & percent)

kVAr-hr (total)

Coolant temperature

Text alarm/event descriptions

Over/under frequency (81 o/u)

kVAr (per phase, average & percent)

4 Programmable relay outputs (Form A)

Low coolant level

True RMS AC metering, 3-phase, +/-2% accuracy

Failure to start (overcrank)

Operating hours

Low coolant temperature

2 Programmable digital outputs

Low oil pressure

Controls:

Digital indication for:

Environmental sealed front face

Overspeed

Volts (L-L & L-N)

Reverse power (kW) (32)

Engine cycle crank

Programmable protective relaying functions:

Cooling System

Fan and belt guards

JWAC

Radiator fan and fan drive

Coolant level sensors

Caterpillar extended life coolant

Coolant drain line with valve

Exhaust System

Flanged faced outlet(s)

Dry exhaust manifold

Fuel System

Fuel cooler; not included with packages without radiator

Fuel priming pump

Secondary fuel filters

Flexible fuel lines - shipped loose

Generators and Attachments

Class H insulation, Class F temperature rise at 40C ambient (105C prime/130C standby)

NEMA standard hole pattern

Anti-condensation space heater

Permanent magnet excitation (PMG)

Form wound

3 Phase brushless, Salient pole

6 Lead

Winding temperature detectors

Right side extension terminal box, busbar connections, top mounted, bottom cable entry

Governing System

ADEM III

Literature

Parts book

Lube System

Gear type lube oil pump

Integral lube Oil cooler

Fumes disposal

Oil drain lines and valve

Oil filter, filler and dipstick

Lubricating oil

Mounting System

Rubber anti-vibration mounts - shipped loose

Rails - engine/generator/radiator mounting

Starting / Charging System

45 Amp Charging alternator

Battery and battery rack w/cables

Battery disconnect switch

24 Volt electric starting motor

General

Right hand servicing

Paint - Caterpillar yellow with high gloss black rails & radiator

SAE standard rotation

Flywheel and flywheel housing-SAE No. 00

Optional Equipment

Air Inlet System

Air inlet protection

Remote air inlet adapters

Heavy duty air cleaners

Dual element air cleaners

Circuit breakers

2000, 2500, 3200, 4000 Amp, 4 Pole, IEC rated Circuit breakers

Circuit breaker harnesses

Masterpact breaker connections

P Frame breaker connections

2000, 2500, 3200, 4000, 5000 Amp, 3 Pole, IEC rated Circuit breakers

Busbar connections

R Frame breaker connections

Cable entry options

1600, 2000, 2500, 3000, 4000, 5000 Amp, 3 Pole, UL-100% rated Circuit breakers

Optional busbar power connections

Power Termination

Circuit breakers, IEC compliant

Control Panel

Voltage raise/lower switch

PC monitoring (Remote and local)

Generator temperature monitoring

Remote speed adjust

Annunciator modules

EMCP 4.4

Vandal proof panel door

Auxiliary box

Customer interface options

Ground

Language options

Load share module options

Mounting group - External box clips

Cooling System

Optional Serpentine radiators

Optional ATAAC radiators

Water level switch gauges

Expansion tanks

Exhaust System

Flexible fittings

Y Adapters

Elbows

Mufflers

Flanges

Flanges and exhaust fittings

Fuel System

Duplex fuel filters

Primary fuel filters

Generators and attachments

Differential current transformers - 8.7 and 15 kV class

Alternator air cleaners

Instrumentation

Pyrometer and thermocouples

Lube System

Manual prelube pump

Electric prelube pumps

Oil level regulator

Lube oil in standard sump

Mounting System

Spring type vibration isolators

IBC Seismic vibration isolators NORAD

Puck style low efficiency lsolators

Power Connections

Neutral ground connections

2700 & 3000 Frame

Grounding groups

Special Tests / Reports

Fuel consumption test

Torsional vibration analysis

Standard engine test charge

IBC Certifications

Generator set consumption test

Generator set test report

PGS Test report @ 1.0 power factor

PGS Test report @ 0.8 power factor

Starting / Charging System

Engine barring group

10, 20, 35 and 50 Amp Battery chargers

Starter cover

Jacket water heaters

24 Volt battery set - Dry

Electric starting motors

Air starting motors

Air pressure regulator

General

US aid emblem

Special paint colors