-
Specifications
-
Standard/Optional Equipment
- Catalog
Maximum Rating
600 ekW
Minimum Rating
600 ekW
Emissions/Fuel Strategy
Non Regulated
Voltage
220 to 480 Volts
Frequency
60 Hz
Speed
1800 RPM
Duty Cycle
Standby
Engine Model
C15 In-line 6, 4-cycle diesel
Bore
5.4in
Stroke
6.8in
Displacement
928in³
Compression Ratio
16.1:1
Aspiration
Turbocharged Air-to-Air Aftercooled
Fuel System
EUI
Governor Type
Adem™A4
Length - Maximum
131in
Width - Maximum
60.6in
Height - Maximum
86.1in
Dry Weight - Genset (maximum)
8364lb
Exhaust
Industrial, residential, critical mufflers
Control panel
Speed and Voltage adjust potentiometers
PLG 4G/3G/Ethernet
Annunciator
Emergency E-Stop
Enclosure
Cat GC enclosure
Generator
Oversize and premium generators
Anti-condensation heater
Excitation: [ ] Permanent magnet excitation (PMG) Excited (PM) [ ] Internally Excited (IE)
Power Termination
Circuit breakers, UL listed
Circuit breakers, IEC compliant
Electrical Options
4 Pole Circuit breaker
Auxiliary contacts
Padlockable circuit breaker
Battery charger
Wet battery
Alternator
Space heater
AVR
Fuel System
Dual wall 8 hour fuel tank
Single wall 8 hour fuel tank with spill containment
Low fuel level shutdown
Low and high fuel level alarms
Manual fuel transfer pump
Fuel transfer system controls
Dual wall fuel tank base
Starting/Charging
Jacket water heater
Heavy duty starting system
Battery chargers
Charging alternator
Oversize batteries
Air inlet system
Single stage air filter
Dual element air filter
Certifications
EU Certificate of Conformance (CE)
EAC Certification
Extended service coverage
3, 4, 5 and 10 Years
General
The following options are based on regional and product configuration:
Single or dual wall integral fuel tanks
Narrow, wide or skid base
Seismic Certification per applicable building codes: IBC 2000, IBC 2003, IBC 2006, IBC 2009, CBC 2007
EU Certificate of Conformance (CE)
CSA Certification
EEC Declaration of Conformity
Integral & sub-base UL listed dual wall fuel tanks
UL 2200 package
Sound attenuated, weather protective or high ambient weather protective enclosure
Automatic transfer switches (ATS)
Single or dual wall sub-base fuel tanks
Enclosures
High ambient sound attenuated enclosures
Exhaust System
Industrial silencer
10 dBA Attenuation silencer
Flexible exhaust fittings
6 and 8 inch elbow kit
End in/end out mufflers - 10, 25 and 35 dBA attenuation
Engine mounted muffler
Manifold and turbocharger guards
6 and 8 inch flange GP
Generator and Attachments
Oversize A Frame generator
Permanent magnet excitation (PMG) generator
Oversize LC frame generator
Ingress protection
LC frame generator
Space heaters
LC frame CIP generator
CIP A Frame generator
Lube System
Manual sump pump
Mounting System
Narrow skid base - replaces standard fuel tank base
Special Test / Reports
PGS Test report @ 1.0 power factor
PGS Test report @ 0.8 power factor
Starting / Charging System
5 Amp single Battery charger
Battery disconnect switch
Jacket water heater
Engine
Cat® C15 Inline 6 cylinder, 4 stroke diesel
Air Inlet
Air cleaner
Control Panels
GCCP 1.1
Governor
Mechanical governor
Cooling
Package mounted radiator
Alternator
A Frame standard alternator
Control Panel
EMCP 4 Genset controller
Fuel Storage
Single wall 8 hour fuel tank
Cooling System
Radiator and cooling fan with guards
Fan drive, battery charging alternator drive
Fuel
Fuel priming pump
Primary fuel filter with integral water separator
Secondary fuel filters
Exhaust
Exhaust flange outlet
Electrical Options
3 Pole Circuit breaker
Neutral earth link
24 Volt battery with rack and cables
Air inlet system
Air cleaner; light duty with disposable element
Lube system
Lubricating oil
Oil drain line with valve
Generator
Matched to the performance and output characteristics of Cat engines
IP23 Protection
Load adjustment module provides engine relief upon load impact and improves load acceptance and recovery time
Mounting system
Captive linear vibration isolators
Lifting provision and drag points
General
Engine and alternator pre paint, Caterpillar yellow
Engine and alternator pre paint, Caterpillar yellow
Paint - Caterpillar yellow except rails and radiators gloss black
Power Termination
Busbar
Generator and Attachments
Power center, IP22
Optional LC Frame generator - IP23 Protection
Mandatory option circuit breaker, IEC, 3 pole, mounted in power centre
Integrated voltage regulator (IVR)
Segregated low voltage (AC/DC) wiring panel
Mounting
Rubber vibration isolators
Governing System
Cat electronic governor (ADEM A4).
Lube System
Oil drain valves
Oil cooler
Mounting System
Captive linear vibration isolators between base and engine-generator includes lifting provisions and termination points for coolant and lube oil drain lines
Starting/Charging
24 volt starting motor
Batteries
24 Volt battery with rack and cables
ALL
Engine
Cat® C15 Inline 6 cylinder, 4 stroke diesel
Air Inlet
Air cleaner
Control Panels
GCCP 1.1
Governor
Mechanical governor
Cooling
Package mounted radiator
Alternator
A Frame standard alternator
Control Panel
EMCP 4 Genset controller
Fuel Storage
Single wall 8 hour fuel tank
Cooling System
Radiator and cooling fan with guards
Fan drive, battery charging alternator drive
Fuel
Fuel priming pump
Primary fuel filter with integral water separator
Secondary fuel filters
Exhaust
Exhaust flange outlet
Electrical Options
3 Pole Circuit breaker
Neutral earth link
24 Volt battery with rack and cables
Air inlet system
Air cleaner; light duty with disposable element
Lube system
Lubricating oil
Oil drain line with valve
Generator
Matched to the performance and output characteristics of Cat engines
IP23 Protection
Load adjustment module provides engine relief upon load impact and improves load acceptance and recovery time
Mounting system
Captive linear vibration isolators
Lifting provision and drag points
General
Engine and alternator pre paint, Caterpillar yellow
Engine and alternator pre paint, Caterpillar yellow
Paint - Caterpillar yellow except rails and radiators gloss black
Power Termination
Busbar
Generator and Attachments
Power center, IP22
Optional LC Frame generator - IP23 Protection
Mandatory option circuit breaker, IEC, 3 pole, mounted in power centre
Integrated voltage regulator (IVR)
Segregated low voltage (AC/DC) wiring panel
Mounting
Rubber vibration isolators
Governing System
Cat electronic governor (ADEM A4).
Lube System
Oil drain valves
Oil cooler
Mounting System
Captive linear vibration isolators between base and engine-generator includes lifting provisions and termination points for coolant and lube oil drain lines
Starting/Charging
24 volt starting motor
Batteries
24 Volt battery with rack and cables
Optional Equipment
Exhaust
Industrial, residential, critical mufflers
Control panel
Speed and Voltage adjust potentiometers
PLG 4G/3G/Ethernet
Annunciator
Emergency E-Stop
Enclosure
Cat GC enclosure
Generator
Oversize and premium generators
Anti-condensation heater
Excitation: [ ] Permanent magnet excitation (PMG) Excited (PM) [ ] Internally Excited (IE)
Power Termination
Circuit breakers, UL listed
Circuit breakers, IEC compliant
Electrical Options
4 Pole Circuit breaker
Auxiliary contacts
Padlockable circuit breaker
Battery charger
Wet battery
Alternator
Space heater
AVR
Fuel System
Dual wall 8 hour fuel tank
Single wall 8 hour fuel tank with spill containment
Low fuel level shutdown
Low and high fuel level alarms
Manual fuel transfer pump
Fuel transfer system controls
Dual wall fuel tank base
Starting/Charging
Jacket water heater
Heavy duty starting system
Battery chargers
Charging alternator
Oversize batteries
Air inlet system
Single stage air filter
Dual element air filter
Certifications
EU Certificate of Conformance (CE)
EAC Certification
Extended service coverage
3, 4, 5 and 10 Years
General
The following options are based on regional and product configuration:
Single or dual wall integral fuel tanks
Narrow, wide or skid base
Seismic Certification per applicable building codes: IBC 2000, IBC 2003, IBC 2006, IBC 2009, CBC 2007
EU Certificate of Conformance (CE)
CSA Certification
EEC Declaration of Conformity
Integral & sub-base UL listed dual wall fuel tanks
UL 2200 package
Sound attenuated, weather protective or high ambient weather protective enclosure
Automatic transfer switches (ATS)
Single or dual wall sub-base fuel tanks
Enclosures
High ambient sound attenuated enclosures
Exhaust System
Industrial silencer
10 dBA Attenuation silencer
Flexible exhaust fittings
6 and 8 inch elbow kit
End in/end out mufflers - 10, 25 and 35 dBA attenuation
Engine mounted muffler
Manifold and turbocharger guards
6 and 8 inch flange GP
Generator and Attachments
Oversize A Frame generator
Permanent magnet excitation (PMG) generator
Oversize LC frame generator
Ingress protection
LC frame generator
Space heaters
LC frame CIP generator
CIP A Frame generator
Lube System
Manual sump pump
Mounting System
Narrow skid base - replaces standard fuel tank base
Special Test / Reports
PGS Test report @ 1.0 power factor
PGS Test report @ 0.8 power factor
Starting / Charging System
5 Amp single Battery charger
Battery disconnect switch
Jacket water heater