ALL
Air Inlet System
Single element canister type with service indicator
Air cleaner
Cooling
Package mounted radiator
Exhaust
Exhaust flange outlet
Fuel
Primary fuel filter with integral water separator
Fuel priming pump
Generator
IP23 Protection
Matched to the performance and output characteristics of Cat engines
Power Termination
Busbar
Starting/Charging
Heavy duty starting system
Charging alternator
Control Panel
Communications:
6 Programmable digital inputs
Programmable protective relaying functions:
Low oil pressure
Environmental sealed front face
Volts (L-L & L-N)
Emergency stop pushbutton
Serial annunciator module data link
Reverse power (kW) (32)
Engine cycle crank
Lamp test
Over/under frequency (81 o/u)
kW-hr (total)
Speed adjust
True RMS AC metering, 3-phase, +/-2% accuracy
Engine cool-down timer
Overcurrent (50/51)
Reverse reactive power (kVAr) (32RV)
kW (per phase, average & percent)
kVAr-hr (total)
Generator phase sequence
Oil pressure (psi, kPa or bar)
Low coolant temperature
Amps (per phase & average)
Generator mounted - rear facing
Over/under voltage (27/59)
Low coolant level
Accessory module data link
kVAr (per phase, average & percent)
Cat ECS controller includes:
Failure to start (overcrank)
2 Programmable relay outputs (Form C)
Cat ECS 100
Overspeed
2 Programmable digital outputs
DC volts
Frequency (Hz)
High coolant temperature
Warning/shutdown with common LED indication of shutdowns for:
Operating hours
4 Programmable relay outputs (Form A)
Coolant temperature
Power factor (per phase & average)
Digital indication for:
Panel lights
Text alarm/event descriptions
Controls:
24 Volt DC operation
Alarm acknowledge
Customer data link (Modbus RTU)
kVA (per phase, average & percent)
Cooling System
Caterpillar extended life coolant
Coolant drain line with valve
Coolant level sensors
JWAC
Radiator fan and fan drive
Fan and belt guards
Exhaust System
Dry exhaust manifold
Flanged faced outlet(s)
Fuel System
Secondary fuel filters
Flexible fuel lines - shipped loose
Fuel cooler; not included with packages without radiator
Fuel priming pump
Generators and Attachments
Form wound
3 Phase brushless, Salient pole
Class H insulation, Class F temperature rise at 40C ambient
(105C prime/130C standby)
Winding temperature detectors
Permanent magnet excitation (PMG)
Anti-condensation space heater
Right side extension terminal box, busbar connections, top
mounted, bottom cable entry
6 Lead
NEMA standard hole pattern
Governing System
ADEM III
Literature
Parts book
Operation & Maintenance Manual
Lube System
Integral lube Oil cooler
Fumes disposal
Oil drain lines and valve
Oil filter, filler and dipstick
Lubricating oil
Gear type lube oil pump
Mounting System
Rubber anti-vibration mounts - shipped loose
Rails - engine/generator/radiator mounting
Starting / Charging System
Battery disconnect switch
45 Amp Charging alternator
Battery and battery rack w/cables
24 Volt electric starting motor
General
Flywheel and flywheel housing-SAE No. 00
SAE standard rotation
Paint - Caterpillar yellow with high gloss black rails & radiator
Right hand servicing
Air Inlet System
Air inlet protection
Remote air inlet adapters
Dual element air cleaners
Heavy duty air cleaners
Circuit breakers
Busbar connections
P Frame breaker connections
R Frame breaker connections
Optional busbar power connections
Circuit breaker harnesses
Masterpact breaker connections
Cable entry options
2000, 2500, 3200, 4000 Amp, 4 Pole, IEC rated Circuit breakers
2000, 2500, 3200, 4000, 5000 Amp, 3 Pole, IEC rated Circuit breakers
1600, 2000, 2500, 3000, 4000, 5000 Amp, 3 Pole, UL-100% rated Circuit breakers
Power Termination
Circuit breakers, IEC compliant
Control Panel
Customer interface options
Mounting group - External box clips
EMCP 4.4
PC monitoring (Remote and local)
Ground
Load share module options
Annunciator modules
Auxiliary box
Language options
Remote speed adjust
Vandal proof panel door
Voltage raise/lower switch
Generator temperature monitoring
Cooling System
Expansion tanks
Optional Serpentine radiators
Water level switch gauges
Optional ATAAC radiators
Exhaust System
Flexible fittings
Elbows
Flanges and exhaust fittings
Flanges
Y Adapters
Mufflers
Fuel System
Duplex fuel filters
Primary fuel filters
Generators and attachments
Differential current transformers - 8.7 and 15 kV class
Alternator air cleaners
Instrumentation
Pyrometer and thermocouples
Lube System
Manual prelube pump
Lube oil in standard sump
Oil level regulator
Electric prelube pumps
Mounting System
Spring type vibration isolators
IBC Seismic vibration isolators NORAD
Puck style low efficiency lsolators
Power Connections
Neutral ground connections
2700 & 3000 Frame
Grounding groups
Special Tests / Reports
IBC Certifications
Generator set test report
Torsional vibration analysis
PGS Test report @ 1.0 power factor
PGS Test report @ 0.8 power factor
Standard engine test charge
Fuel consumption test
Generator set consumption test
Starting / Charging System
Starter cover
Electric starting motors
Air pressure regulator
24 Volt battery set - Dry
Jacket water heaters
Engine barring group
10, 20, 35 and 50 Amp Battery chargers
Air starting motors
General
Special paint colors
US aid emblem
